What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
10.06.2025 04:47

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
These devices are installed between the “hot” and “neutral” and protective ground.
There are two important concepts here.
It also is a device that limits the change in current flow.
nine
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Can a twin flame runner be happy in a karmic relationship?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
but I think this circuit , shows a few more pieces.
2024–10–10[John johnson John Johnson ]
Do flat Earthers really exist? Why do they believe the Earth is flat?
Because the load is inductive, the current lags the voltage.(by a bit).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
What is lightning?
I post the exact comment here.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
So, the voltage could go up to 500 volts, and the fuse will not open up.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is where this question deviates from being a 'generic' question, and becomes more specific.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
The MOV will conduct when the voltage exceeds 50% of line voltage.
These are simplified answers to the original question, and does not change anything I wrote above.
Isn’t freedom of speech and expression an absolute right?
One
At one ohm, the resistor has a maximum of 1 watt power.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Will Canadians still buy American products?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
At least they know the answer if they wanted it.
He then describes Rainy Season and Lightning.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This device then solves the entire problem.
First Sentence:
the problem then depends on "how fast does the fuse operate?".
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
[image of Common-mode choke]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
What does a fuse do?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
a photo is worth a thousand words.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–16 [ OO OLAOYE OYEBODE ]
This is where the MOV conducts again, and dissipated the energy.
[old diagram got deleted by accident]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Here is a simplified AC power diagram.
For this case there are devices called Metal oxide varistors (MOV).
An AC voltage/ current source, and an ac inductive load.
Now when you have a certain ac resistance, then a current flows in a loop.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–14 [Omar Gharbi Omar Gharbi ]
This one hit behind the barn.
The other is “what does a “fuse” do?”
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
There are three different concepts here that are getting confused.
what exactly is a ‘surge’ protector?
He then asserts :
A circuit breaker is similar, but is resettable.
The bolt then partially travels down the line to your home.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is 'the assistant's answer'
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Upvotes:
Can the fuse protect the electronic devices from lightning instead of a surge protector.
The third is lightning and “how it gets conducted into a home.”
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
but this device (an Inductor) … impedes the rapid changes in the current.
In schematic diagrams this is the symbol for a fuse:
(Dc diagram shown, AC is similar).
Edit 2024–10.
One is “what exactly is in a ‘surge protector’ ? ”
Barnstars:
eight
He then describes the function of a fuse.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
But it can get overloaded, and no longer works.
It seems Mohan does not understand the difference between a comment and an Answer.
A fuse is a non-resetable over current circuit protector.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
so, what happens?